The DA212 is a professional 1U, 2-input / 12-output or 6-channel stereo audio distribution amplifier. Input gain is adjustable on two multi-turn trimming potentiometers. Each of the 12 outputs can be selected for mono mix and / or half gain.
| Application | Audio, video and radio studios, OB vans, editing suites |
|---|---|
| Input gain | Variable -40 to + 25dB on 2 x 20 turn trimming potentiometers |
| Input connectors | 2 x female 3-pin XLR |
| Input impedance | >50KOhms |
| Output connectors | 12 x male 3-pin XLR |
| Output level | 13 Volts peak |
| Output impedance | <50Ohms |
| Frequency response | -3dB (5Hz to 75KHz) / -0,5dB (20Hz to 20KHz) |
| Distortion | THD <0,01% (20Hz to 20KHz, including noise) |
| Signal-to-noise ratio | >80dB |
| Crosstalk | Better than 80dB |
| Construction | Fiberglass PC board inside powder coated mild steel chassis |
| Power requirement | 110 / 220 volt AC, 10 VA |
| Dimensions | 1U 5mM face plate, chassis 203mM deep |
| Weight | 3,5 Kg nett |
| Accessories | Power cord |
International Limited Warranty
Crane Electronics cc (Crane) warrants to the first purchaser of the this product that it is free from material and workmanship defects. Crane's sole obligation under this warranty shall be to provide necessary parts and labour to correct defects, if any, which appear within twelve (12) months from date of purchase. This warranty does not cover appearance, or if the equipment has been, according to Crane's judgement:
- • Subjected to misuse, abuse, negligence or accident
• Repaired or otherwise altered by persons not authorised by Crane
• Connected, installed, adjusted or used for a purpose other than that for which it was designed
To the maximum extent permitted by applicable law, in no event shall Crane be liable for any special, incidental, indirect, or consequential damages whatsoever, including, without limitation, damages for loss of business profits or business interruption, arising out of the use or inability to use this product.
Please note that this unit must be installed by a trained technician only. Failure to do so may invalidate this warranty.
The voltage for this unit is factory adjusted for either 110V or 220V AC. Before installing,please ensure that the unit is set to the correct voltage for your country.
